Ceiling and flooring works

We modify metallic floor bearing structure with respective floor panels.

We supply and install carpet tiles. 

Ceiling finishes in buildings create a sandwich space below the roof or floor slab above, which conceals projecting structural elements, recessed light fixtures, electrical wiring conduits, and air-handling ductwork. The ceiling must be accessible to change or maintain the service elements located above it, and the most common ceiling system is composed of wet felted mineral fiber panels, painted, and perforated on one side for sound absorption. The removable panels are supported on a grid of formed sheet-metal tee bars or zee tracks, which are suspended by wires from the structure above. Where accessibility is not important, and a smooth finish is desired, suspended gypsum board ceilings can be used.

Floor finishes in commercial and institutional uses make considerable use of synthetic-fibre carpeting and vinyl composition tile. In areas of higher traffic harder surfaces may be used—for example, cut stone tiles of marble or granite, ceramic tile applied with epoxy adhesive to the substrate, or terrazzo. Terrazzo is made in two ways, traditional and thin set. In the traditional form a four-centimetre (1.5-inch) layer of cement and sand grout is poured over the substrate; a grid of metal divider strips to control shrinkage cracks is set on the hardened surface, and grout mix of coloured cement and marble chips is poured between the strips. After hardening, the surface is machine polished to expose the marble chips and metal dividers. Thin-set terrazzo is made by placing the metal strips and pouring the binder and marble chips directly onto the subfloor, without the underbed of cement and sand. It is generally possible only when epoxy resins are used in place of cement binders. Terrazzo is available in many colours, and it forms a hard, smooth, and durable surface that is easily cleaned. 

​